The Best 3 Hp Pump

The original 011018 Drive/software is no longer being produced or supported therefore the 011018 is being replaced by the 011028 energy Star certified: Meets strict energy efficiency criteria set by the U.S. Environmental Protection Agency & the U.S. Department of energy Energy saving to 90%* versus traditional pumps 8 programmable speed settings & built-in timer to ensure the pump runs at optimum speed & duration ultra-efficient permanent magnet motor design reduces noise & vibration for greater efficiency & longer pump life dramatically quieter operation – as low as 45 decibels – about 4 times quieter than most traditional-style pumps** totally enclosed fan-cooled (TEFC) design & low average operating speed makes intelligent the quietest pump on earth fully compatible with Pentair automation & Controls & other brands of digital pool/spa controls for managing pump, heating, lighting, spa jets & water features built in Diagnostics protect the pump for longer service life wef 6.1 the 3.95 *savings based on variable speed pump compared to a single-speed pump running 12 hoursper day at an average of $0.16per kwh in a 20, 000 gallon pool. Actual savings may vary based on local utility rates, pool size, pump run time, pump horsepower, pump rpm, plumbing size & length, pump model, Service factor & other hydraulic factors. ** compared to noise level of typical 1.5 HP single-speed pump.

Product Description

Specification:

• Wattage: 270 watts
• Maximum Head: 23 Feet
• Intake: Screened
• Discharge: 1″ FNPT
• Housing: Glass-filled polypropylene
• Shaft Seal: Nitrile
• Approximate Weight: 14 Pounds
• Warranty: 3 Year manufacturer’s warranty

Little Giant APCP-1700 (577301) is a 115-Volt Automatic Pool Cover Pump with a low energy consumption, permanent-split capacitor (PSC) 1/3HP motor. It has Screened Intake, 1 in. FNPT Discharge, Glass-filled polypropylene Housing and 25 in. power cord. The APCP-1700 model activates in approximately 2 in. of water and deactivates in approximately 1.5 in. of water. The APCP-1700 has a wide base design for needed stability. Intermittent Liquid Temperature is up to 120 degree F. Little Giant APCP-1700 is ideal for removing water from all types of pool covers. The 1700 GPH performance was obtained through a 1 in. I.D. tube, with friction losses neglected. Using a 3/4 in. garden hose 50 foot long reduces this performance to approximately 500 gallons per hour due to friction losses in the hose. If your area frequently has heavy rain falls, (1 in. – 2 in. per hour), it may be necessary to use 1 in. tubing. This should be available in most pool supply stores.

From the Manufacturer

This Little Giant Automatic Submersible Pool Cover Pump removes standing water from pool covers and is ideal for household water transfer applications. It comes with a removable intake screen for easy cleaning and maintenance. It has a built in handle for portability and ease of placement and removal. It connects to a 3/4-Inch garden hose connection. It also has a integrated float switch for reliable automatic operation – activates in 2-Inch of water.

SUBMERSIBLE WIRE SPLICE KIT INCLUDED WITH EVERY PUMP PURCHASE!

IMPORTANT: THIS PUMP DOES NOT REQUIRE A CONTROL BOX!

Our Deep Well Pump is ideal for the supply of fresh water to rural homes, farms, and cabins that have 4 inch and greater diameter drilled wells. It is a durable workhorse that will keep you in flow for years to come. Brand new pump in the box! NOT ‘Manufacturer Refurbished’.

-The pump has a thermally protected motor with a 95°F maximum work temperature to keep from overheating while in use.

-2-wire + ground wire design for easy provision and energy efficiency.

-Stainless steel casing keeps this pump sturdy and functioning for years.

-The well pump submersible is easy to install and extremely versatile.

-Patented impeller design provides high flow up and high head, for better performance and longer life than most other well pumps.

-This pump model features a built in check valve, however this check valve is only used to prevent water from going back in the pump and causing backspin of the impellers, but if you are going to use the pump in a pressure system YOU NEED TO USE AT LEAST ONE EXTERNAL CHECK VALVE IN THE PIPE, the valve in the pump won’t fulfill that function.

-1 year warranty.

NOTICE: Our pumps are checked for physical damage before they’re shipped. As soon as you receive it check for any damage that might have occurred during shipping, and please report it to Amazon if you see any.

NOTICE 2: This pump is designed to be used in clear pure water only, even an small amount of sand diluted in the water will damage it, make sure your well pumps clear water before you install it, this is important because damages caused by sand are not covered by the warranty.

Pn Series features watertight cable entrance with anti-wicking block. Permanently lubricated sealed ball bearings rated b-10 60, 000 hours. Built in motor protection. Continuous duty air filled copper wound highly efficient motor. Corrosion resistant stainless steel motor casing. Dual inside mechanical with silicon Carbide vs. Ceramic bottom faces. Ball Type air Relief Valve. Solids handling semi-vortex impeller.

Product Description

Superior Pump builds pumps that are truly Built to Last and are 100 percent factory tested. Superior Pump uses quality components including solid copper motor windings, heavy duty stainless steel jacketed shaft seals, double o-ring seals on motor plate, and electronically controlled split capacitors. Superior Pump model 91330, 1/3 HP thermoplastic submersible utility pump with 10 foot power cord and ¾-inch garden hose adapter, will move water up to 2400 gallons per hour. Equipped with suction screen to filter out large debris and handles up to 1/8-inch solids with ease. Base of the pump is designed to fit the hub of a standard 6-inch floor drain. This pump is UL/CUL listed and CSA certified and backed by a 1 year warranty.

From the Manufacturer

Superior Pump is a family owned and operated Pump Company specializing in residential / light commercial duty pumps. Headquartered in Minneapolis, Minnesota, Superior Pump was founded in 1999 after spending years in the pump industry dating back to the 70’s, and with a plumbing background starting in St Paul Minnesota dating all the way back to 1885. Superior Pump adheres to our strong core family values, selling the absolute highest quality product possible. Known for building durable pumps, Superior Pump concentrates on quality throughout the engineering, manufacturing and testing processes. Quality products, strong warranties, excellent USA based customer service – Superior Pumps Built to Last!

Designed specifically for turf irrigation, this self-priming pump provides outstanding performance to horsepower ratio. Our LP Series is truly heavy duty, offering standard high-end features that our competitors only offer as pricey add-ons. Professionals trust the LP Series to deliver trouble-free performance.Brass impeller – durable and low maintenance with the longest life in its classSilica carbide seal – proven toughness stands up to less than ideal situationsCast iron body and internal components – heavy duty for long-term performance and reliability COMMON APPLICATIONSResidential turf irrigation: Drawing water from ponds, lakes, streams, cisterns and shallow wellsBooster: Boost domestic water pressure for use in irrigationWater transfer ADVANTAGES Durable and long lasting – While many centrifugal turf irrigation pumps are made out of plastic, which wears and warps, our cast iron construction and brass impeller mean that our self-priming pumps are built to stand the test of time, even in more unusual or difficult environments. Testing in tough conditions shows Munro LP series pumps last up to four times as long as typical competitors products. Industry leading performance to horsepower – The proof is in our curves. In many cases a lower horsepower Munro LP pump will meet the same GPM performance that you’d expect to see only in higher horsepower pumps. With greater starting torque and an efficient run cycle, our pumps truly lead the pack. Easy to install and maintain – With two priming ports and a durable steel base plate, installing a Munro LP Series is a snap. When it’s time to maintain or winterize the pump, you’ll love our two drain valves. A stainless steel wear ring reduces oxidation and friction, minimizing wear and repairs. If you do have to service the pump, stainless steel bolts and a dry-socket design provide easy access.

Traditional pumps operate at set, unchangeable speeds. Those speeds are almost always higher than required. As a result, they overpower the jobs they’re assigned to do, which wastes energy. Intelliflo allows custom programming of optimum pump speeds for specific tasks such as filtering, heating, cleaning, spa jets and waterfalls. for virtually all applications, the optimum speed is lower than the preset, unchangeable speeds of older pumps. When water moves more slowly for longer periods, it helps reduce the occurrence of algae that forms more easily when water is pumped briskly and then allowed to rest for long intervals. Your filter works more effectively because it has more time to sift out particles from the water, and because particles aren’t forced through the Filter media under needlessly high pressure. Automatic chemical dispensers and chlorinators also work better when water is kept moving.